Digi XBEE-PRO S3B - RT (DI2 Configuration); Diagnostic Commands; ER (Receive Count Error)

Configuration and commands Diagnostic commands
XBee®-PRO 900HP/XSC RF Modules
219
After a device receives a serial byte and it receives no other byte before the RO timeout, the
tranmission begins.
Binary command
0x21 (33 decimal)
Parameter range
0 - 0xFFFF [x 200 µs]
Default
0
Bytes returned
2
RT (DI2 Configuration)
Sets or displays the behavior of the DI2/RTS/CMD line. You must use RT to enable RTS flow control or
binary programming.
Binary command
0x16 (22 decimal)
Parameter range
0 - 2
Parameter Configuration
0 Disabled
1
Binary Command enable
2
RTS flow control enable
Default
0 (disabled)
Bytes returned
1
Diagnostic commands
The following commands are diagnostic commands.
ER (Receive Count Error)
This count increments when a device receives a packet that contains integrity errors of some sort.
When the number reaches 0xFFFF, the firmware does not count further events.
Sets or displays the receive error. The error-count records the number of packets partially received
then aborted on a reception error. This value returns to 0 after a reset and is not non-volatile (that is,
the value does not persist in the module’s memory after a power-up sequence).