Digi XBEE-PRO S3B - Networking Specifications; General Specifications; Antenna Options

XBee-PRO XSC specifications Networking specifications
XBee®-PRO 900HP/XSC RF Modules
189
Networking specifications
The following table provides the networking specifications for the device.
Specification
XBee-PRO XSC (S3*
hardware)
XBee-PRO XSC (S3B
hardware)
Frequency range 902-928 MHz (located in the 900 MHz ISM band)
Spread spectrum Frequency hopping
Network topology Point-to-point, peer-to-peer, point-to-multipoint
Channel capacity 7 hop sequences share 25 frequencies
Board-level serial data
interface(S3B)
3V CMOS UART (5 V-tolerant)
3 V CMOS UART
*
The S3 hardware variant is a legacy design that is obsolete. New and old designs should use the
S3B hardware variant.
General specifications
The following table describes the general specifications for the devices.
Specification XBee-PRO XSC (S3* and S3B hardware)
Module board size 3.29 cm x 2.44 cm x 0.546 cm (1.297 x 0.962 x 0.215 in)
Dimensions do not include connector/antenna or pin
lengths
Weight 5 to 8 grams, depending on the antenna option
Connector Two rows of 10 pins, 22 mm apart with 2 mm spaced
male Berg-type headers
Operating temperature -40 to 85 ºC (industrial)
*
The S3 hardware variant is a legacy design that is obsolete. New and old designs should use the
S3B hardware variant.
Antenna options
The following table describes the antenna options for the devices.
Specification XBee-PRO XSC (S3* and S3B hardware)
Integrated wire ¼ wave monopole, 8.26 cm (3.25 in) length, 1.9
dBi gain
RF connector Reverse-polarity SMA or U.FL
Impedance 50 Ω unbalanced
*
The S3 hardware variant is a legacy design that is obsolete. New and old designs should use the
S3B hardware variant.