UTM-00339 | Rev 19
Page 121 of 253
DetNet South Africa Copyright © 2021
1. The user may set:
• Absolute time (at any time)
• Hole number but not counting direction
• Det number (if multiple primed and not loading per deck)
• Increment values and if increments are to be factored in for the next hole (Incrementing /Decrementing /
Manual)
2. The Up/Down arrow keys may be used as follows:
• Middle UP/DOWN arrow functions:
• Used to increment/decrement the delay with 1ms offset
value.
• Right UP/DOWN arrow functions:
• Used to increment/decrement the delay with inter-hole
offset value.
• Side Arrow keys
• Only available when tagging group/row hole and det. This key will change the det number.
• or
• Adjust the hole number and corresponding delay of that hole.
To Next Page
Loading...