DigiShot plus.4G - Page 205

UTM-00339 | Rev 19
Page 205 of 253
DetNet South Africa Copyright © 2021
10. To remove a Commander from the blast:
• Press button,
• Highlight Commander to be
removed,
• Press ,
• Then press Soft button to
remove.
11. To add a removed Commander
• Press + Button.
12. Remote Blast
• Wait if message “Not ready yet” is displayed,
• User will be prompted to Scan Authorise Key once all the bench Commanders are
out of grace period and ready to blast.
13. Scan to Authorise
• The user will be prompted to scan an Authorise Key programmed with the
authorised token from the 3rd party application to start the blasting process.
• Scan the Authorise Key at the back of the DigiShot
®
Plus 4G Commander.
• Once the Authorised key is scanned and the token is validated, the Commander
will allow the user to scan the Red BlastCard.
14. Scan Key
• Scan the RED BlastCard at the back of the DigiShot
®
Plus
4G Commander,
• Enter the corresponding PIN,
• Press to continue,
The user is also provided with an option to Arm the Commander without the need to
connect the tagger via an AutoArm function. The AutoArm function will allow the user to
scan a no PIN yellow BlastCard and if there are no errors present; program and move to
the waiting for next press state. The user will then have to press next for 2 seconds and
the unit will then be ready to arm.