The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential. Any disclosure, copying, distribution to third
party is strictly prohibited.
25
Mechanical Movement Sensor
How to assemble the sensor box
SENSOR
Screws B Screws B
Screws A
Clamps
Clamps
Screws (A)
Sha!
36 m/m
Sheathing
Speedometer
Cable
Sensor Prove
1. Take out the internal wire from the
sheathing.
2. Shorten the sheating 36 m/m
3. Insert both ends of the sheathing in
the clamps and tight the 4 screws B
4. Loosen the 4 screws (A) and insert
the internal wire. Do not tight the 4
screws A*.
* Attention: when you insert the internal
wire, the dummy shaft must come out
and be dispose
A) Re-assemble the trasmission cable in the car, connecting it
to both the gear box and the odometer.
B) Drive about 100 mts to allow the internal wire to fi nd its
original position.
C) Tight the 4 screws A.
D) Insert the sensor’s prove.
E) Fix the sensor’s cap to end the sensor’s assembling opera-
tion and to have the sensor fully operative
Electrical Connec! ons
Red cable = Power Supply (5 Vcc to 24)
White cable = Output Signal (open collector)
Shield = Ground
To Next Page
Loading...