The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential. Any disclosure, copying, distribution to third
party is strictly prohibited.
43
Tariff Show
The Tariff Show is a viewer function included in the “SelfFunction Menu”. So it must be included in the settings
of the tariff programmed.
The Tariff Show allows to view the 7 most important metrological values programmed in up to 8 blocks of the
tariff (t1, t2, t3, t4, t5, t6, t7, and t8).
Depending on the country that taximeter will be used, the values showed for distance will be expressed in the
local distance measurement system. And the values showed for prices will be, of course, in the local currency.
These 7 values are shown in the following parameters (in order of appearance) for each programmed Block, the
procedure is showed in the following page (33):
Amount for Ini! al Drop =A Initial Amount
Seconds for First Unit Wai! ng Time = b
Time 1st Unit
Seconds for Following Units Wai! ng Time = b1
Time other Units
First Unit Distance = c
Distance 1st Unit
Following Units Distance = c1
Distance Other Units
Price per distance = d
Amount per km
Price per ! me = E
Amount per Hour
Also in the Tariff Show viewer is possible to display the 4 programmed extras values after the 8 tariff blocks:
Amount Extra number 1 = F1
Extra Amount
Amount Extra number 2 = F2 Extra Amount
Amount Extra number 3 = F3
Extra Amount
Amount Extra number 4 = F4 Extra Amount
To Next Page
Loading...