Digitax X-one - ?Trip by Trip”; Events Memory Buffer; Trip by Trip

The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential. Any disclosure, copying, distribution to third
party is strictly prohibited.
38
“Trip by Trip”
Events Memory Buffer
The “Trip by Trip” is a long memory buffer where the taximeter store the events informations (trips, shifts, etc.).
It can be able to record and store, depending the buffer version, till 9000 events.
It’ s a F.I.F.O. Memory kind (First in - First out): the last event recorded that exceed the memory events number
take the place of the • rst recorded event. If Tariff question 314 = YES, the taximeter is blocked when the
F.I.F.O. buffer is full and record are not deleted.
It can be possible to print out all the events or print events starting from the last print out.
How to print out all “Trip by Trip” memory content
How to print “Trip by Trip” events starting from the last print out
OP
OP
OP
OP
K2
K2
K4
K4
K1
K2
K1
K2
STATIS
STATIS
1
1
1 1
1 1
0
0
1 2
1 3
0
0
1 2
1 3
FOR HIRE
FOR HIRE
FOR HIRE
FOR HIRE
Memory Data
Memory Data
Memory Block
Memory Block
Memory Location
Number
Memory Location
Number
Trip by Trip Memory
Location
Trip by Trip Memory
Location
Select For Hire position.
Be sure printer is connected and Powered ON
Press
F2 and F3 at the same time.
The Main display (3) will show “Statis” for a few seconds.
The secondary display (5) will show: in the left digit the
block (1 o 2) and in the right digit the number of block
location (1-45).
The main display (3) will show in the right digits the
selected location data value.
Press F3 button to reach the Memory location n. 2
Press
F5 button to print out all the “Trip by Trip” memory
location Content.
Press
F1 button to end the print out procedure and go
back to
For Hire position.
Select
For Hire position.
Press
F2 and F3 at the same time.
The main display (3) will show “STATIS” for a few
seconds.
The secondary display (5) will show: in the left digit the
block (1 o 2) and in the right digit the number of block
location (1-45).
The main display (
3) will show in the right digits the
selected location data value.
Press
F3 button to reach the Memory location n. 3
Press
F5 button to print out all the “Trip by Trip” memory
location Content from the last print out procedure.
Press
F1 button to go back to For Hire position.
Counters
Counters
Counters
Counters
Counters
Counters
Counters
Counters