The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential. Any disclosure, copying, distribution to third
party is strictly prohibited.
30
Pre-Selection of the Tariff
In any of these modes it is possible to have different functions activated by pressing one of the 5 taximeter’s but-
In order to avoid possible fraudulent use of the taximeter, it is possible to ac• vate an alterna• ve way of star• ng a
trip, that allows to select the desired tari• when the taximeter is s• ll in For Hire posi• on, and so to start the trip
directly with the pre-selected tari• .
Tari• pre-selec• on is ac• vated by changing the following setup ques• ons:
Q32=yes
Q2=0
Q3=number of tari! s
When Pre-Selection is enabled:
pressing F1 key from “For Hire” position is shown the
Tariff Selection menu, and the driver has to select the
tariff number.
To start with scrolling through the tariffs with F3 (up)
and F2 (down).
The selected tariff is confi rmed by pressing F1 key
again, and so the taximeter starts the trips directly
with the Pre-selected tariff.
If the tariff is not selected in 5 seconds, the taximeter
goes back to “For Hire” position
For Hire
FARE €
For Hire
FARE €
TARIFF 3
For Hire
FARE €
TARIFF 4
For Hire
FARE €
TARIFF 2
FARE €
TARIFF 2
FARE €
To Next Page
Loading...