The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential. Any disclosure, copying, distribution to third
party is strictly prohibited.
44
Tariff Show
The procedure to use the Tariff Show is as follows:
1. Keep pressed F3 for few seconds to enter
in the menu selection
2. Select TAR-SH by pressing F3
3. Confi rm by F5 the Tariff Show viewer
4. To go to the next programmed value press F5
5. To go to the previous programmed value press
F4
Every time F5 is pressed you will go to the next pa-
rameter index in the same order as specifi ed before
for each programmed block (up to 6).
When the last parameter index of the last block
(t6) is shown, by pressing F5 again the Tariff Show
viewer will display the Four Extras programmed val-
ues (from F1 to F4):
To exit from Tariff Show menu and go back to
For
Hire position, press F1.
...
TAR-SH
SelFun
A T1 60.00
10.21
For Hire
TimeFARE RsTar
1200.00
B T1
60.00
A T1
90.0
B1 T1
4000.0
C T1
F1 T0 0.95
F2 T0 0.95
F3 T0 0.95
F4 T0 0.95
To Next Page
Loading...