The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential. Any disclosure, copying, distribution to third
party is strictly prohibited.
70
Engine Input
The engine input (also called ignition input) can be used to trigger X-One Android device
startup and/or shutdown. The engine digital input of the device has to be connected to the
ignition key, and the AITP setup must be modi• ed to manage this input.
Usually the system shutdown is managed by the user application, not directly by the AITP. The
application can read the AITP digital inputs status, and when the engine is OFF it can decide
to shutdown, following its own logic and having all the time to perform a proper logout and
disconnection sequence before issuing the shutdown command to the AITP.
Alarm
Alarm mode must be enable by setup, and Alarm status is set by the AITP when it detects the
Panic/Alarm Input low for some time. The customer application can read the Alarm status, and
can do what is required to manage the alarm.
At the end is the customer application that has to clear the alarm with a speci• c command of
the AITP DLL.
The application can also set the alarm, not only clear it.
It’s possible to setup the AITP so to disable device power off if is in alarm, and if the panic but-
ton is pressed when the device is off, than is possible to setup the AITP to turn it on, eventually
in Stealth mode.
To Next Page
Loading...