DigiTech JamMan SOLO XT User Manual

12
Quick Start
1. Make necessary connections (see
“Connection Diagrams”).
2. Connect the included power adapter
to the JamMan Solo XT.
3. Select an empty memory location
using the <UP/DOWN> buttons
(LOOP and SINGLE LEDs will be off).
4. Set the <LOOP LEVEL> control
to the 12 o’clock position and the
<RHYTHM LEVEL> control to the
minimum position.
5. Press the <PEDAL SWITCH> to
initiate recording. Recording will begin
and you should start playing.
6. Once done recording, press the
<PEDAL SWITCH> again to set the
loop end point and initiate playback.
7. You can now listen to and play along
with the loop.
8. If you want to record an overdub,
press the <PEDAL SWITCH> again
and play along with the loop (the
STATUS LED will light yellow).
9. Press the <PEDAL SWITCH> again
to stop overdubbing and playback will
continue.
10. Quickly press the <PEDAL SWITCH>
twice to stop playback.
11. Press the <STORE> button twice to
store the recorded loop.

DigiTech JamMan SOLO XT Specifications

General

Sampling Rate	44.1 kHz
A/D/A Conversion	24-bit
Type	Looper Pedal
Storage	Internal, SD Card (optional)
Inputs	1 x 1/4" (instrument), 1 x 1/8" (aux in)
Outputs	1 x 1/4" (mono)
USB	1 x Mini-B
Power Supply	9V DC power supply