16
Recording a Loop Using Auto Record
See “Setup > Auto Record” for information on enabling the Auto Record feature.
1. Select an empty memory location
using the <UP/DOWN> buttons
(LOOP and SINGLE LEDs will be off).
2. (Optional) If you wish to use
the Rhythm guide Track, set the
<RHYTHM LEVEL> control to
the 9 o’clock position then tap the
<TEMPO> button a few times at the
rate you want the phrase tempo to
be. This will create an auto quantized
loop. You will begin to hear the
Rhythm Guide Track. The beats will
be indicated by a flashing TEMPO
button LED, flashing red on the first
downbeat and green on all remaining
beats of the measure. When using the
Rhythm Guide Track, time signature
can be manually set to a different time
signature other than the default of 4
beats per measure (see “Setup > Time
Signature
”).
3. Press the <PEDAL SWITCH> to arm
recording, indicated by a flashing red
STATUS LED. Begin playing to start
recording. Recording will be indicated
by a solid red STATUS LED.
NOTE: When Auto Record is armed
for recording, pressing the <PEDAL
SWITCH> a second time will disarm
Auto Record (Status LED will stop
flashing).
4. As soon as you’re done recording,
press the <PEDAL SWITCH> again to
stop recording and initiate playback.
5. Quickly press the <PEDAL SWITCH>
twice to stop loop playback.
6. Press the <STORE> button twice if
you wish to store the loop.
To Next Page
Loading...
Need help?
General
