DigiTech JamMan SOLO XT User Manual

49
Auto Record
The Auto Record feature is off by default. This feature allows the JamMan Solo XT to
be armed for recording, but not actually begin recording until a signal is detected at
one of the JamMan Solo XT’s inputs.
To turn Auto Record on or off:
1. Press the <SETUP> button seven
times or until Arc appears in the
display.
2. Press the <UP/DOWN> buttons to
turn Auto Record on and off.
3. Once the desired selection has been
made, press the <PEDAL SWITCH>
to exit the Setup menu.
NOTE: The Auto Record parameter is a global parameter, so storing is not necessary. Auto Record
is only available when recording new loops and is only active after selecting an empty memory
location. For information on using the Auto Record feature, see “Operation > Recording a Loop
Using Auto Record”.

DigiTech JamMan SOLO XT Specifications

General

Sampling Rate	44.1 kHz
A/D/A Conversion	24-bit
Type	Looper Pedal
Storage	Internal, SD Card (optional)
Inputs	1 x 1/4" (instrument), 1 x 1/8" (aux in)
Outputs	1 x 1/4" (mono)
USB	1 x Mini-B
Power Supply	9V DC power supply