48
Reverse
The Reverse feature lets you playback a recorded loop file in reverse. Changes to the
Reverse parameter must be stored to memory if you wish to retain the changes.
To Reverse a loop:
1. Press the <SETUP> button six times
or until RSe appears in the display.
2. Press the <UP/DOWN> buttons to
turn the Reverse feature on and off.
3. Once the desired selection has been
made, press the <PEDAL SWITCH>
to exit the Setup menu.
4. Press the <STORE> button twice to
store the changes.
NOTE: The Reverse feature is non-destructive. You can always come back into the Setup menu and
turn the Reverse feature off if you wish the loop to playback normally again.
To Next Page
Loading...
