DigiTech JamMan SOLO XT User Manual

56
Optional FS3X Footswitch
The optional FS3X Footswitch gives you hands-free control over the following
functions: loop selection, tempo, play, stop, and clear.
Mode Switch
When the selected loop
memory is empty, this
footswitch can be used to
set the loop tempo. If the
loop is recording, playing, or
overdubbing, this footswitch
will stop any of these
functions with a single press.
If this footswitch is pressed
and held, it will clear any new
loop or overdubs made to an
existing loop that have not
been stored.
Down Switch
This footswitch selects the
next lower memory location.
Press and hold for two
seconds to scroll through the
memory locations more
quickly.
Up Switch
This footswitch selects the
next higher memory
location. Press and hold for
two seconds to scroll
through the memory
locations more quickly.

DigiTech JamMan SOLO XT Specifications

General

Sampling Rate	44.1 kHz
A/D/A Conversion	24-bit
Type	Looper Pedal
Storage	Internal, SD Card (optional)
Inputs	1 x 1/4" (instrument), 1 x 1/8" (aux in)
Outputs	1 x 1/4" (mono)
USB	1 x Mini-B
Power Supply	9V DC power supply