DigiTech JamMan SOLO XT User Manual

28
Deleting a Loop
The JamMan Solo XT uses both internal memory and optional external Micro SD/
SDHC memory cards for the storage of loop files. Loops can be deleted one at a time
to make room for other loops. You can delete loops from both internal memory and
external memory.
WARNING! The deletion of a loop cannot be undone! You should backup any loops you wish to
keep, using the JamManager XT loop librarian management software, before deleting them.
To delete a loop from internal or external memory:
1. Select the desired memory location
using the <UP/DOWN> buttons.
2. Press and hold the <STORE> button
for two seconds until the display
shows ErL then release. The STORE
button LED will begin flashing waiting
for a delete confirmation.
NOTE: If the display shows Eri or ErC,
you have held the <STORE> button too
long and need to press the <PEDAL
SWITCH> to abort the procedure and
start over.
3. Press the <STORE> button again. The
display will read E? (Erase Loop?).
4. To continue with the deletion of the
loop, press and hold the <STORE>
button until the display reads dEL then
release. To abort procedure, press the
<PEDAL SWITCH>.

DigiTech JamMan SOLO XT Specifications

General

Sampling Rate	44.1 kHz
A/D/A Conversion	24-bit
Type	Looper Pedal
Storage	Internal, SD Card (optional)
Inputs	1 x 1/4" (instrument), 1 x 1/8" (aux in)
Outputs	1 x 1/4" (mono)
USB	1 x Mini-B
Power Supply	9V DC power supply