DigiTech JamMan SOLO XT - Setup Menu - Tempo; Setting Loop Tempo

43
Tempo
The Tempo setup menu displays the loop tempo in BPMs (beats per minute) and
allows you to manually adjust the tempo setting. You can first set a tempo by using
the <TEMPO> button and then adjust it further in this menu. An empty loop has no
tempo so pressing the <UP/DOWN> buttons while in the Tempo menu will set a
default tempo of 120BPM. You can also adjust (Time Stretch) the tempo of a stored
loop using this option without changing pitch of the phrase (see “Operation > Time
Stretching a Phrase
”).
To set the Tempo before recording a loop:
1. Select an empty memory location
using the <UP/DOWN> buttons
(LOOP and SINGLE LEDs will be off).
2. Press the <SETUP> button twice until
tPO appears in the display.
3. Use the <UP/DOWN> buttons to
adjust the tempo. If a tempo has not
been set, pressing either button once
will set the default tempo of 120BPM.
4. Once tempo is set, press the
<STORE> button twice to store
the changes or press the <PEDAL
SWITCH>
to exit the Setup menu
without storing.
NOTE: You can also set the tempo by tapping the <PEDAL SWITCH> (when Pedal Tempo is
enabled). See ”Operation > Recording a Loop (Auto Quantize)”.