DigiTech JamMan SOLO XT User Manual

44
Time Signature
The JamMan Solo XT allows you to set a time signature before recording a loop. The
default time signature for empty loops is 4 beats per measure. Each time signature
setting represents how many beats are in the measure (i.e. a setting of 2 would
contain 2 beats per measure, a setting of 6 would contain 6 beats per measure, etc.).
Time signature can be adjusted from 2 to 15 beats per measure.
To set the Time Signature before recording a loop:
1. Select an empty memory location
using the <UP/DOWN> buttons
(LOOP and SINGLE LEDs will be off).
2. Press the <SETUP> button three
times, or until SIg appears in the
display.
3. Press the <UP> and <DOWN>
buttons to change the time signature.
4. Once the desired selection has been
made, press the <STORE> button
twice to store the changes before
recording your loop or press the
<PEDAL SWITCH> to exit the Setup
menu without storing.
NOTE: Whenever a tempo has been set, the TEMPO button LED will flash red on the first
downbeat of the measure and then green on the remaining beats of the measure. Time signature can
only be changed on empty loops. When accessing the time signature of a previously recorded loop,
the time signature will appear in the display, but it cannot be changed.

DigiTech JamMan SOLO XT Specifications

General

Sampling Rate	44.1 kHz
A/D/A Conversion	24-bit
Type	Looper Pedal
Storage	Internal, SD Card (optional)
Inputs	1 x 1/4" (instrument), 1 x 1/8" (aux in)
Outputs	1 x 1/4" (mono)
USB	1 x Mini-B
Power Supply	9V DC power supply