DigiTech JamMan SOLO XT User Manual

15
Once the tempo is established, record your loop and set the loop end point at the
end of a measure. If your timing was a little early or late, not to worry, the JamMan
Solo XT automatically adjusts the loop length to the measure length set by the Tempo
and Time Signature.
NOTE: The JamMan Solo XT can record and playback loops up to 10 minutes long.
Recording a Loop (Free-Form)
Pedal Tempo Off (Default)/Auto Record Off (Default)
1. Select an empty memory location
using the <UP/DOWN> buttons
(LOOP and SINGLE LEDs will be off).
2. Press the <PEDAL SWITCH> to
initiate recording and begin playing.
3. As soon as you’re done recording,
press the <PEDAL SWITCH> again
to stop recording and initiate playback.
Quickly press the <PEDAL SWITCH>
twice to stop loop playback.
4. Press the <STORE> button twice if
you wish to store the loop.

DigiTech JamMan SOLO XT Specifications

General

Sampling Rate	44.1 kHz
A/D/A Conversion	24-bit
Type	Looper Pedal
Storage	Internal, SD Card (optional)
Inputs	1 x 1/4" (instrument), 1 x 1/8" (aux in)
Outputs	1 x 1/4" (mono)
USB	1 x Mini-B
Power Supply	9V DC power supply