20.
When JamMan Solo XTs are initially connected via the JAMSYNC
jacks, Syn will appear in the slave’s display, indicating JamSync
connection is established. The SYn indicator will also be displayed
when initially powering up devices which are slaved to a master.
Properly connected slaves will also be indicated by a decimal
segment which will light in the display, as shown to the left. If you
have a slave connected and do not see these indicators, check your
JamSync cable.
The following directions describe how to record loops on multiple JamMan Solo XTs
using JamSync. These directions assume you are using the factory default settings in
the JamMan Solo XTs. Devices should be configured as shown in the following table:
PARAMETER MASTER SETTINGS SLAVE SETTINGS
Pedal Tempo Off Off
Auto Record Off Off
Record Sequence Record » Play » Dub Record » Play » Dub
Loop Level 12 o’clock 12 o’clock
Rhythm Level 9 o’clock Off (fully counter-clockwise)
To Next Page
Loading...
