DigiTech JamMan SOLO XT User Manual

58
indicating Loop 3 is cued up to play
once Loop 1 finishes. Once Loop 3
begins playing, the display
will stop
flashing.
Memory locations 1, 2, and 3 are used for this example, but any memory locations can
be used for multiple loop playback.
NOTE: If either the <UP> or <DOWN> footswitch on the FS3X is pressed less than two seconds
before the end of a playing loop, the JamMan Solo XT will not have enough time to cue up the next
loop and the current loop will continue to play one more time. If any overdubs were recorded
during this type of performance, they will be lost when the next loop is selected and begins playing
back. You can also use the <UP/DOWN> buttons to change loops during playback. However, this
does not allow for hands-free operation. See “Operation > Multiple Loop Playback (Cueing Loops)”.

DigiTech JamMan SOLO XT Specifications

General

Sampling Rate	44.1 kHz
A/D/A Conversion	24-bit
Type	Looper Pedal
Storage	Internal, SD Card (optional)
Inputs	1 x 1/4" (instrument), 1 x 1/8" (aux in)
Outputs	1 x 1/4" (mono)
USB	1 x Mini-B
Power Supply	9V DC power supply