Dinli DL702 - Engine Removal and Installation

【6-2】
E
NGINE
Removal and Installation
Engine Removal
● Thoroughly clean the ATV engine and chassis.
● Clean work area.
● Drain coolant and engine oil.
● Remove the seat.
● Remove the side fenders.
● Remove the rear propeller shaft.
● Disconnect the battery lead wires
● Remove front and rear rack and fender.
● Remove the water hoses.
● Remove Subharness assembly coupler [1] and Coolant Temperature
sensor coupler [2].
CAUTION
When disconnecting the battery lead wires, be sure to disconnect
the ○,
－
battery lead wire first.