【6-19】
NGINE
CAM CHAIN TENSIONER
Inspection
Check the push rod slides smoothly when releasing stopper.
If it does not slide smoothly, replace the cam chain tensioner with a
new one.
CAM CHAIN GUIDE
Inspection
Check the contacting surface of the cam chain guide for wear and
damage.
If it is found to be damaged, replace it with a new one.
CYLINDER
Cylinder distortion
Check the gasketed surface of the cylinder for distortion with a
straightedge and thickness gauge, taking a clearance reading at
several places as indicated.
If the largest reading at every position of the straightedge exceeds the
limit, replace the cylinder.
Cylinder Distortion
Service Limit 0.05 mm
Cylinder bore
● Check for damage or ware on bore surface.
● Measure the cylinder bore at total 6 positions; top, middle and
bottom positions and axial (Camshaft) and right angle directions.
Cylinder bore
Service limit 102.000 to 102.020mm
To Next Page
Loading...
