【7-7】
LECTRICAL SYSTE
3. Check the charging conditions with a voltmeter (Normal
charging voltage should be 12.8V)
4. This battery may be installed only if replaces a similar sealed
type battery.
5. Keep away from high temperature of fire.
6. In the case of an accident sulfuric acid may escape. Avoid
contact with skin, eyes or clothing.
Charging Method
Normal Charge: 1.8A 5~10 hrs
Fast Charge : 18A 0.5 hrs
New Battery:
Use of conventional lead-acid batteries is not recommended.
Battery type: GS, GTX20L-BS
Charging Procedure
● Remove the battery (see Battery Removal).
● Connect a charger to the battery BEFORE plugging it in or
turning it on.
● Set the charging rate and time according to the battery condition
previously determined
● Turn the charger off or unplug it, then disconnect it from the
battery.
● Check battery condition.
If the battery condition indicates that is not fully charged,
additional charging time is necessary.
CAUTION
NEVER attempt to add electrolyte or water to the
maintenance-free design and construction. Doing so will
damage the case and shorten the life of the battery.
CAUTION
Always remove the battery from the vehicle for charging. Do
not use a high rate battery charger, as is typically employed at
automotive service stations, unless the charger rate can be
reduced to the level required. Charging the battery at a rate
higher than specified may ruin the battery. Charging at a high
rate causes excess heat, which can warp the plates and cause
internal shorting. Higher-than-normal charging rates also
cause the plates to shed active material. Deposits will
accumulate, and can cause internal shorting.
To Next Page
Loading...
