DAG2000 Series FXS Voice Gateway User Manual
8
Dinstar Technologies Co., Ltd.
Switch between incoming calls, If not in session, flash/hook will switch a
new channel for new call.
2.6 Sending and Receiving Fax
2.6.1 DAG（FXS）support four fax modes:
1）T.38（FoIP）
2）Pass-Through
3）Modem
4）adaptive
2.6.2 T. 38 and Pass-Through
T.38 is the preferred method because it is more reliable and works well in most network
conditions. If the service provider supports T.38, please use this method by selecting T.38
as fax mode (default). If the service provider does not support T.38, pass-through mode
may be used. If you have problems with sending or receiving Fax, toggle the Fax Tone
Detection Mode setting.
3. Local IVR Operation
3.1 Inquire IP address
Analog phone connected with FXS ports of device, then pick up, after dial tone, dialing
*158# to inquire LAN port IP address and dialing *159# to inquire WAN port IP address.
To Next Page
Loading...
