Dinstar DAG2000-32 - Basic Operations; 2.1 Phone Call

DAG2000 Series FXS Voice Gateway User Manual
4
Dinstar Technologies Co., Ltd.
2. Basic Operations
2.1 Phone Call
2.1.1 Phone or Extension Number
1）Dial the number directly and wait for 3 seconds (Default “ No dial timeout ”);
2）Dial the number directly and press #.
2.1.2 Direct IP Calls
DAG series device with FXS port allow two parties directly call through IP address. The user
need only a simulation with the FXS port unit equipment linked together and set up calls
not registered.
Elements necessary to completing a direct IP call：
1) Both DAG serial and other VoIP Device, have public IP addresses;
2) Both DAG serial and other VoIP Device are on the same LAN using private IP
addresses;
3) Both DAG serial and other VoIP Device can be connected through a router using public
or private IP addresses (with necessary port forwarding or DMZ).
Operation Process：
1）Pick up the analog phone then dial “*47”
2）Enter the target IP address.
【Note】：No dial tone will be played between step 1 and step 2
Examples:
If the target IP address is 192.168.0.160, the dialing convention is *47, then
192*168*0*160. Followed by pressing the “#” key or wait 3 seconds. Complete
signaling interactive soon after, he was called the unit can be heard ringing.
【Note】：You cannot make direct IP calls between FXS0 to FXS1 since they are using same
IP. It only supports the default destination port 5060.