Dinstar DAG2000-32 - Syslog Parameter

DAG2000 Series FXS Voice Gateway User Manual
48
Dinstar Technologies Co., Ltd.
Notify
Equipment send notify parameters to NM server
Trap Configuration
Trap Flag
Version of SNMP
Trap IP
Device to inform the NM server’s IP address. The IP can
be configured the same with source IP in community,
also be different.
Trap Port
Default service port is 162
Trap Community
The same with “community” in community
configuration
Note: After configuration, please restart equipment to take effect.
Users can manage and configure gateway on remote NM server through SNMP configuration. But in order to
security, recommend this option to open when needed.
4.11.2 Syslog Parameter
Syslog is a protocol used in (TCP/IP) network transmission of record of the standard file
information.
Syslog agreement belongs to a kind of master slave agreement: Syslog sender will sent a small
text information (less than 1024 bytes) to syslog the receiver. The receiver are: “syslogd”、
“syslog daemon” or syslog server. Syslog message can be transferred by TCP/UDP.
Syslog level：
• none Used to misarrange
• debug Not including function conditions or the question of other information
• notice importance common conditions
• warning Early warning information
• error Stop error conditions of tools or some part of the realization of the function
subsystem
Figure 4.11-2 Syslog Parameter Configuration
Enable send CDR, and then send communication information to syslog server.