DAG2000 Series FXS Voice Gateway User Manual
9
Dinstar Technologies Co., Ltd.
3.2 Factory Reset
After picking up, dial *166*000000#, then onhook and restart after “Setting successful”.
3.3 Configure LAN Port’s IP Address
Before configuration, please ensure:（1）The device is power on; （2）deviceis connectingto
network;（3）Telephone is connecting to FXS port of device.
1) Configure dynamic IP address by DHCP：
Offhook; Dial “*150*2#”; Onhook;
If the equipment hint success, after 10 seconds, and restart the
equipment.(Power-off then power-on)
2) Configure Static IP address
Offhook; Dial “*150*1#”; Onhook;
Then configure IP and mask as follow:
• Configure IP address：
Offhook; input “*152*172*16*0*100# ”; onhook
• Configure subnet mask：
Offhook; input “*153*255*255*0*0# ”; onhook
• Configure gateway IP address
Offhook; input “*156*172*16*0*1# ”; onhook.
3) Query the IP address of device: Offhook, input“*158#”
4) If the DAG serial uses PPPoE method to get IP address，it need to configure by
web browser.
【Note】：The telephone will play voice prompt “Setting successfully” if the step is correct
To Next Page