Dinstar DAG2000-32 - Page 38

DAG2000 Series FXS Voice Gateway User Manual
33
Dinstar Technologies Co., Ltd.
Figure 4.8-10 Feature Code Configuration Interface
Inquire LAN port IP address
Dial*158# to obtain device WAN port IP address
Inquire WAN port IP address
Dial*159# to obtain device WAN port IP address
Inquire Phone Number
Dial*114# to obtain port account
Setting IP Mode
*150*0#, means pppoe modem, *150*1#, means static IP,
*150*2#, means obtain IP address by DHCP, *150*3#, means
pppoe.
Network Work Mode
*157*0#, set network work mode to routing mode; *157*1#, set
network work mode to bridge mode
Configure IP Address
*152*+IP, set gateway IP address
Network subnet mask configure
*153*+subnet mask, set gateway subnet mask
Network Gateway Configure
*156*+gateway IP, set gateway
Renew DHCP
*193#, set dynamic IP again
Access Web by Wan in Rout Mode
Allow access web through WAN port：*160*1#; don’t allow access
web through WAN port：*160*0#
Reset Factory
*166*000000#, reset factory
Restart Device
*111#, restart device
Call onhold/offhold
When call process, dial*# into call hold.（Recovery the call through
hook flash or *#）
Call by IP
Directly dial the end user IP to call
Call Waiting Activate
*51#, enable call waiting function
Call Waiting Deactivate
*50#, forbid call waiting function