36
© 2009 Directed Electronics. All rights reserved.
Step Function
1
Auto Learn Standard Configuration (default)
The auto learn configuration will automatically set ups the remote
button configuration. Note: You cannot change the configuration
of the remote control buttons.
2
Delete remotes: This feature will erase all remotes from the memory
of the system. This is useful in cases when a customer’s remote is
lost or stolen. Note: Does not reset the programmed features of the
system or reset the Virtual Tach setting.
3
Reset Features: This resets all the features of the system to the fac-
tory default settings. Note: Does not delete the remotes from the
system or reset the Virtual Tach setting.
4
Virtual Tach Reset: Deletes all previously learned values for Virtual
Tach, and on the next remote start sequence the unit will begin
virtual tach initialization. Note: The “Zap” feature on the Bitwriter
does not reset the Virtual tach setting.
4.Transmit. While holding the Valet/Program switch, press
the button on the remote control. The siren chirps to
confirm that the code has been successfully programmed
or the selected feature has been reset. It is not possible to
teach a remote control button to the system more than once.
5. Release. Once the code is learned, or the feature reset,
the Valet/Program switch can be released.
You can advance from programming one step to another
by releasing the Valet/Program switch and tapping it to
advance steps and then holding it.
To Next Page
Loading...
Need help?
General
