37
© 2009 Directed Electronics. All rights reserved.
If you want to program Step 3 after programming Step 1, release the Valet/
Program switch, press it twice and release it to advance to Step 3. Then press
it once more and hold it. The siren chirps three times and the LED flashes three
times to confirm it is ready to receive the code from the transmitter.
.
Learn Routine is exited if:
Door is closed.•
The ignition is turned off.•
The program switch is pressed too many times.•
More than 15 seconds elapses between steps.•
To Next Page
Loading...
