49
© 2009 Directed Electronics. All rights reserved.
2-5 DOOR TRIGGER ERROR ON/OFF: This feature controls the error chirp that
is generated if the system is armed with the door trigger active. This is useful in
vehicles that have a long dome light delay after the door has been closed. If
the system is armed before the dome light has turned off, the security system will
generate the door trigger error chirp. If this error chirp is not desired, use this
feature to disable the door open error chirp. If the bypass chirp is turned off, no
bypass chirp will be generated, even if a door is accidentally left open.
2-6 IGNITION CONTROLLED DOME LIGHT SUPERVISION ON/OFF: If turned
on, the system will turn on the dome light for 30 seconds when the ignition is
turned off. The optional dome light supervision feature must be installed as de-
scribed in the Wire Connection Guide.
2-7 UNLOCK OUTPUT—1, 2 PULSES: This will program the unlock output to
one or two pulses. When the double pulse unlock feature is turned on, the BLUE
door lock harness wire will supply two negative pulses instead of a single pulse.
At the same time, the GREEN door lock harness wire will supply two positive
pulses instead of a single pulse. This makes it possible to directly interface with
double pulse vehicles without any extra parts for unlock and lock outputs (see
below).
2-8 LOCK OUTPUT—1, 2 PULSES: This will program the lock output to one or
two pulses. When the double pulse lock feature is turned on, the BLUE door
lock harness wire will supply two positive pulses instead of a single pulse. At the
same time, the GREEN door lock harness wire will supply two negative pulses
instead of a single pulse.
2-9 FACTORY ALARM DISARM WITH TRUNK RELEASE - ON/OFF. In the
default setting the factory alarm is disarmed anytime the trunk release control
button is pressed. When programmed off, there is no pulse output when the
button controlling the trunk release is pressed.
2-10 FACTORY ALARM DISARM—WITH UNLOCK(1), BEFORE UNLOCK(2),
REMOTE START ONLY (3): In the default setting the factory alarm is disarmed
any time the button(s) controlling Unlock is pressed. “Before Unlock” output to
disarm the factory alarm activates before unlock and remote start are activated.
The “Remote Start Only” output disarms the factory alarm before remote start is
activated.
To Next Page
Loading...
Need help?
General
