Prepare - 102 JT100/JT100 All Terrain Operator’s Manual
Check Supplies and Prepare Equipment
JT Mode
• Install SaverLok
®
body, shuttle stop, roller, and roller pin for Mach 1 pipe.
• Use standard transition sub and beacon housing. Select soil bit based on jobsite conditions.
• Use auger type anchors.
• Load JT pipe and pipe box onto unit.
• Move mode selector switch to JT position.
Assemble Accessories
Fire Extinguisher
Identify location (shown) for fire extinguisher. Mount a fire extinguisher near the power unit but away from
possible points of ignition. The fire extinguisher should always be classified for both oil and electric fires. It
should meet legal and regulatory requirements.
IMPORTANT: Use conversion kit (p/n 190-1548).
IMPORTANT: Do not put JT pipe into a large All Terrain pipe box. Pipe can jam and box can be
damaged. Use JT pipe box.