Conduct a Bore - 120 JT100/JT100 All Terrain Operator’s Manual
Clamp Pipe
Clamp Pipe
Clamp on pipe when joint is centered between
wrenches (1 and 2). Always clamp on the larger
diameter areas on either side of the tool joint face.
Read operator’s manual. Know how to use all controls.
Your safety is at stake.
273-475
To help avoid injury:
• Ensure that any downhole tool or pipe in wrenches is attached to spindle or removed before
transport. Wrenches can open after engine shutdown.
• Clamp only where indicated. Clamping anywhere else on the pipe will weaken the pipe. Pipe can
later break, even when operating under normal loads.
To Next Page
Loading...
