Systems and Equipment - 180 JT100/JT100 All Terrain Operator’s Manual
Diagnostic Codes
2. Count the flashes as described above. The first time will flash code 12, which indicates the beginning
of the list.
3. To repeat the same code, press and hold “Resume” switch. To move to the next code press and hold
the “Set” switch.
4. When all codes are done, pressing “Set” returns to the beginning, code 12.
Continuous Review
1. Press and hold “Resume” switch until the Control Cycle light (green) turns on and the Diagnostic light
(red) begins to flash (approximately 2 seconds).
2. Count the flashes as described above. The first time will flash code 12, which indicates the beginning
of the list.
3. When the first code is complete, the Control Cycle light (green) turns off. The code will flash two more
times without the Control Cycle light (green).
4. The Control Cycle light (green) turns on again and the next code is flashed once, then repeated two
more times without he Control Cycle light (green).
5. This is repeated for all active codes and will start over at the beginning, code 12.
To Next Page
Loading...
