Ditch Witch JT100 - Page 213

Service - 212 JT100/JT100 All Terrain Operator’s Manual
50 Hour
Check Hex Stub
Shine flashlight into spindle and check condition of
hex stub(1) every 50 hours. Replace if rounded.
To replace:
1. Remove SaverLok
®
connection. Do not
remove indexing dowels from spindle.
2. Slide hex stub (1) and spring (2) off of drive
shaft.
3. Check condition of hex stub (3) and replace if
needed.
4. Check o-ring on inner water swivel (seal kit)
and replace if needed.
5. Install new spring and hex stub.
6. Install saver sub. See “Check SaverLok Body” on page 238.
Lube SaverLok
®
Wrench Collar and
Sliding Output Shaft
Lube with EPS spray in locations shown every 50
hours.
Check Compressor Belt
Check compressor belt (1) tension every 50
hours. Adjust tension of compressor belt as
shown.