10.4 Change the Password value 20
10.5 Enter the programming level Pr1 21
10.6 Enter the programming level Pr2 21
10.7 Enter the programming level Pr3 22
11 FUNCTION MENU “ M” KEY 23
11.1 Alarm list: show and reset 23
11.2 Compressor overload alarm reset 24
11.3 Compressor overload password. 24
11.4 Alarm log list 24
11.5 Erase the Alarm log list 25
11.6 Password value of the alarm list 25
11.7 Disable – enable a single circuit 25
12 TABLE OF THE OUTPUT STATUS IN ALARM CONDITION
26
12.1 ALARM: “A” type and status of the loads in case of alarm 26
12.2 ALARM: “b” type and status of the loads in case of alarm 28
12.3 ALARM: “C” type and status of the loads in case of alarm 29
13 TABLE OF THE PARAMETERS 30
14 BLACK-OUT 53
To Next Page
Loading...
Need help?
General
