DKS 1802 - Programming the Welcome Message; Reset Welcome Message to Factory Default

1802-065-D-10-14
29
The welcome message, followed by the instruction message, scrolls across the screen from right to left when the system is not
in use. The welcome message can be a maximum of 48 characters (spaces count as a character) and is entered into the system
memory in three lines of 16 characters each. The example below shows how the sample message was divided into three lines.
Use the blank matrix to organize your own message.
Default Welcome Message = WELCOME TO THE DKS PHONE SYSTEM HAVE A NICE DAY
After organizing your welcome message in the matrix above, follow the instructions below to enter the message into the
system. After each desired letter, number or space is displayed on the directory, remember to press
*
to enter that character.
Spaces count as a character and must be entered into memory as a character. After a complete line has been entered, press
*
to enter the line, then start the next line.
Example: WELCOME TO THE DKS PHONE SYSTEM HAVE A NICE DAY
WE L COME T THE
DAYHAVE NICEA
DO
KS PHONE SYST EM
Line 1
Line 2
Line 3
123456 78 9101112131415 16
Line 1
Line 2
Line 3
123456 78 9101112131415 16
1. Press and enter your four-digit MASTER CODE (beep).
The LCD display will read: 1ST LINE WEL MSG.
2. Enter the characters into Line 1 (refer to 3.3.1 for reference). Remember to press (beep) after each character.
3. After the last character in the line has been entered, press (beep) to enter the entire block (16 characters max.).
The LCD display will read: 2ND LINE WEL MSG.
4. Repeat steps 2 and 3 to enter characters into Line 2.
The LCD display will read: 3RD LINE WEL MSG.
5. Repeat steps 2 and 3 to enter characters into Line 3.
7. Press (beep) to enter all three lines into the system memory.
9. The new user message will begin to scroll across the screen.
?
?
?
?
?
?
?
?
0
0
OPER
OPER
8
8
TUV
TUV
3.3.2 Programming the Welcome Message
This programming sequence allows you to reset the welcome message to the factory default.
Default Welcome Message = WELCOME TO THE DKS PHONE SYSTEM HAVE A NICE DAY
3.3.3 Reset Welcome Message to Factory Default
1. Press and enter your four-digit MASTER CODE (beep).
2. Press (beep) to reset the message to default, OR (beep) to keep the current programmed message.
?
?
?
?
?
?
?
?
2
2
ABC
ABC
8
8
TUV
TUV
1
1
SP
SP
0
0
OPER
OPER