DKS 1802 - SECTION 4 - SYSTEM OPERATING INSTRUCTIONS; General Instructions; Guest Instructions; Responding to a Guest Call

1802-065-D-10-14
36
This programming sequence sets up ONE time zone for the FOUR-digit entry codes to activate the system relays. This time
zone uses a range of four-digit entry codes (Boundary numbers) and can be programmed for certain days of the week. This time
zone can be turned ON and turned OFF after it is programmed (see operating instructions 4.2.4 to turn ON or OFF the
programmed entry code time zone).
3.5.3 Four-Digit Entry Codes Time Zone
1
1
SP
SP
0
0
OPER
OPER
1
1
SP
SP
0
0
OPER
OPER
1. Press and enter your four-digit MASTER CODE (beep).
2. Press (beep) to turn time zone ON, OR (beep) to turn time zone OFF.
3. Enter the four-digit BEGINNING hour and minutes, then press (beep).
DO NOT use military (24 hour) time format, simply enter the hour (2 digits) and the minutes (2 digits). For example, 8:30 is
entered as 0830. AM or PM gets set on the next step.
4. Press (beep) for AM, OR (beep) for PM.
5. Enter the four-digit ENDING hour and minutes, then press (beep).
DO NOT use military (24 hour) time format, simply enter the hour (2 digits) and the minutes (2 digits). For example, 8:30 is
entered as 0830. AM or PM gets set on the next step.
6. Press (beep) for AM, OR (beep) for PM.
7. Enter the seven-digit days of the week, then press (beeeeeep). (Sun = 1, Mon = 2, .....Sat = 7)
All seven digits MUST be entered, to skip any days of the week the time zone will NOT be active, enter # in place of a day.
Example 1: to have a time zone active on Saturday and Sunday ONLY (Sun = 1, Sat = 7), enter 1 7 # # # # #.
Example 2: to have a time zone active on Monday thru Friday ONLY (Mon = 2, Tues = 3, ......Fri = 6), enter 2 3 4 5 6 # #.
8. Enter the LOWER four-digit entry codes boundary number, then press (beep).
Entry codes LOWER than this number will NOT activate relays when the entry code time zone is ON.
9. Enter the UPPER four-digit entry codes boundary number, then press (beep).
Entry codes HIGHER than this number will NOT activate relays when the entry code time zone is ON.
10. Press together to end this programming sequence (beeeeeep).
?
?
?
?
?
?
?
?
6
6
MNO
MNO
3
3
DEF
DEF
1
1
SP
SP
0
0
OPER
OPER
0
0
OPER
OPER