1802-065-D-10-14
2
TABLE OF CONTENTS
SPECIFICATIONS
Important Notices FCC - United States, DOC - Canada
General Information Installation Guidelines and Safety Information
SECTION 1 - INSTALLATION
1.1 General Installation
1.1.1 Remove Components from Enclosure
1.2.1 Install Enclosure
1.2 Surface Mount Dimensions
1.3 Flush Mount Dimensions
1.4 Memory Chip Replacement
1.5 Postal Lock Installation
SECTION 2 - WIRING
2.1 Wiring Guidelines
2.1.1 Power
2.1.2 Wire Runs
2.1.3 Grounding
2.1.4 Surge Suppression
2.1.5 Ferrite Filter
2.2 Terminal Descriptions
2.3 Telephone Entry System Wiring and Adjustments
2.3.1 Speaker Volume, Microphone and Feedback
2.3.2 Click Sensitivity - Use for Rotary-Dial Phones ONLY
2.3.3 LCD Display Contrast
2.3.4 Master Code Switch
2.3.5 Ring Pin Jumper
2.3.6 Hands Free - Hand Set Jumper
SECTION 3 - PROGRAMMING
3.1 General Programming
3.1.1 Master Code
Overview for System Programming
3.1.2 Single or Multiple Systems
3.1.3 Relay Strike Time
3.1.4 “Tone Open” Sound ON or OFF
3.1.5 Talk Time
3.1.6 Tone Open Numbers
3.1.7 Touch-Tone / Rotary-Dial
3.1.8 Programming Switch Input 1 and Switch Input 2
3.1.9 Number of Rings Before Telephone Entry System will Answer
3.1.10 PBX Line Access Code Programming
3.1.11 Star Key Function
3.1.12 Keypad Function (DTMF Tone Programming)
3.1.13 System to Stay On-Line or Hang-Up after Touch Tone Number Pressed
3.1.14 Automatic Hang-Up Function
3.2 Phone Number Programming
3.2.1 Programming the Directory Code Length
3.2.2 Programming Phone Numbers
3.2.3 Programming Area Codes (Area Code Reference Numbers)
3.2.4 Programming Area Codes WITH Area Code Reference Numbers
3.2.5 Deleting Individual Phone Number
3.2.6 Deleting ALL Phone Numbers
3.2.7 Display / Delete Phone Numbers with UNKNOWN Directory Codes
3.2.8 Display Phone Numbers with KNOWN Directory Codes
1
4
5
6
6
7
8
9
10
11
12
13
13
13
13
14
14
14
15
16
17
17
17
18
18
18
19
19
19
20
21
21
21
21
22
22
22
23
23
23
23
24
24
24
24
25
25
26
26
26
27
27
To Next Page
Loading...
