2.5 Main Terminal Description
1. 24V COMMON
2. RADIO RELAY - SINGLE BUTTTON ACTIVATION INPUT
When gate is closed, input will open gate.
When gate is open and auto close timer is turned on, input will re-set and hold timer.
When gate is open and auto close timer is turned off, input will close gate.
When gate is closing, input will reverse gate.
3. 24V RADIO POWER
4. SINGLE BUTTON ACTIVATION INPUT / EXIT LOOP LOGIC OUTPUT
If SW 1,switch 3 is ON, this input is identical to Single Button Activation Input (terminal 2).
If SW 1, switch 3 is OFF, this terminal becomes the logic output of the EXIT loop detector.
5. 24V COMMON
6. Not used
7. 24V COMMON
8. REVERSE INPUT / SHADOW INPUT
When gate is closed, this input has no affect on the gate operator.
When gate is open and auto close timer is turned ON, input will re-set and hold timer.
When gate is open and auto close timer is turned OFF, input will prevent gate from closing.
When gate is closing, input will reverse gate if SW 1, switch 5 is OFF. If switch 5 is ON
(shadow operation), the gate will not reverse.
9. 24V COMMON
10. DRY RELAY CONTACT
Operation of relay is dependent on setting of SW 2, switches 1 and 2. Relay contacts can be
set for Normally Open (NO) or Normally Closed (NC) operation. Contact rating is 1 amp
maximum at 24 Volts.
Switch 1 OFF, Switch 2 OFF: Relay activates when gate is OPEN.
Switch 1 OFF, Switch 2 ON: Relay activates when gate is OPEN, OPENING or CLOSING.
Switch 1 ON, Switch 2 OFF: Relay activates when gate is OPEN or OPENING.
Switch 1 ON, Switch 2 ON: Relay activates when gate is OPENING or CLOSING.
11. DRY RELAY CONTACT
12. 24 VDC MAGLOCK OUTPUT
13. 24 VDC MAGLOCK OUTPUT
14. Not Used
15. Not Used
16. Not Used
17. ALARM RESET
18. 24V COMMON
19. 24 VAC INPUT
20. 24 VAC INPUT
Page 21
To Next Page
Loading...
