XR500/XR100 User’s Guide 25User Menu
Armed Areas Display
Displays all armed area names in the system.
The Armed Areas display lists all of the names of the armed areas
in your system at the keypads.
Using the Armed Areas Function
1. Access the User Menu.
2. Press COMMAND until ARMED AREAS? displays.
3. Press any Select key. The keypad displaysthe rst armed
area name. To scroll through the list of armed area names,
press the COMMAND key.
4. If there are no armed areas, the keypad displays NONE.
Outputs On Off
Allows you to manually turn the system or door access relay
outputs ON and OFF.
This function is used to individually turn your system relay and
access door outputs ON and OFF. Your system may use these
outputs to control door access, interior and exterior lighting,
heating, air conditioning, or other appliances.
The names and numbers of the relays connected to your system
are located in the System Setup section of this guide.
Outputs can be turned ON or OFF regardless of the output settings
in Schedules.
Your system may be programmed to require that your user code
prolehaveaccesstoareasassignedtothekeypad.INVALIDAREA
displays when your user code does not have access to the keypad’s
areas and the output does not turn on.
Under certain conditions, some outputs cannot be turned
on. If you select a restricted output, the keypad displays
CANNOT TURN ON.
Turning the Outputs ON and OFF
1. Access the User Menu.
2. Press COMMAND until OUTPUTS ON/OFF? displays.
3. Press any Select key to display OUTPUTS DOOR.
4. Select OUTPUTS or DOOR for the type of output you want to
turn ON or OFF.
5. Enter the output number you want to turn ON or OFF. The
output number displays.
6. With the output number displayed, select ON or OFF. The
output then turns ON or OFF depending on your selection,
and remains in that state until you change it. The keypad
displaystherst12charactersoftheoutputordoorname
followed by either ON or OFF for four seconds to provide
visualvericationoftheaction.PresstheCOMMANDkeyto
end the four second display.
7. The system automatically returns to the output or door
option and a new output can be selected to turn ON or OFF.
Refer back to step 4.
8. Press the Back Arrow key to exit the User Menu.
Browser Feature
If you are unsure of the output number, refer to
Appendix B at the back of this guide for a diagram showing you
how to use the built-in Outputs ON/OFF browser.
To Next Page
Loading...
Need help?
General
