DMP Electronics XR100 User Manual

34 XR500/XR100 User’s Guide User Menu
Note: Changing a user code does not change the user number.
8. The display changes to PROFILE NO: -.  Select the prole
number to assign a set of authorized functions to the user
codeasoutlinedintheUsersProleChart.
9. After entering the prole number, the keypad displays
USER#CHANGEDforvesecondsfollowedbyUSERNUMBER:
-. This display allows you to enter another user number to
change. Press the Back Arrow key twice to exit the User
Menu.
Changing Own User Code
1. Access the User Menu.
2. Press the COMMAND key until USER CODES? displays. Press
any Select key.
3. The display changes to USER CODE: * * * * * *. Press any
Select key.
4. Type your new user code. Press Command.
Browser Feature
Refer to Appendix B for diagrams showing you how to use the
Change User Codes browser.
Deleting User Codes
1. Access the User Menu.
2. Press COMMAND until USER CODES? displays.
3. Press any Select key. The keypad displays ADD DEL CHG
B AT.
4. Select DEL to delete a user code from the system. To delete
ausercode,youmusthaveausercodewithaprolethat
has user code authority.
9. At the PROFILE NO:   - display, enter a prole number
from 1 to 99, and press COMMAND. The displays shows
USER # ADDED.
If BAT (Batch) was chosen in step 4 instead of ADD, the
next available user number is automatically selected and
only steps 6 and 7 repeat.  The User Prole assignment
is automatically selected for the next user based on the
previous user entered. This batch entry method speeds up
user entry in large systems.
Browser Feature
Refer to Appendix B at the back of this guide for a diagram showing
you how to use the Add User Codes browser.
Changing User Codes
Tochangea usercode,youmusthaveausercodewithaprole
that has user code authority.
1. Access the User Menu.
2. Press the COMMAND key until USER CODES? displays.
3. Press any Select key. The keypad displays ADD DEL CHG
B AT.
4. Select CHG to change a user code.
5. At the USER NUMBER: - option, enter the user number to
change and press COMMAND.
Refer to the System Setup section for the number of user codes
available for your system.
6. The display changes to USER CODE: * * * * * *. Press any
Select key and enter the new user code. Press COMMAND.
7. The display then shows the current user name. Press any
top row key to clear. See Entering Names in Appendix C to
enter a new name.

DMP Electronics XR100 Specifications

General

Brand	DMP Electronics
Model	XR100
Category	Security System
Language	English