DMP Electronics XR100 - Display Events; Service Request; Fire Drill; Starting a Fire Drill Test

42 XR500/XR100 User’s Guide User Menu
Display Events
Allows you to review up to 12,000 past door access and system
events. There are six event types:
Zone Activity - Zone alarms, troubles, and restorals.
Opening and Closing - System arming and disarming.
User Code - Adding, deleting, and changing user codes.
Schedule Changes - Adding, deleting, and changing schedules.
Door Access - Each door access function used at a keypad.
Supervisory - Problems with system hardware components.
The system memory holds a maximum of 12,000 past events for 45
days. Any event older than 45 days automatically clears from the
system memory. Also, once the full 12,000 events are stored, any
new event causes the oldest event to be cleared. See Appendix A
for Display Events.
Service Request
<RXU XVHU FRGH SURÀOH PD\ EH SURJUDPPHG IRU 6HUYLFH 5HTXHVW
This User Menu feature allows you to simply press any Select key
when SERVICE REQUEST? displays and have the system automatically
send a “Request for Service” message to the central station. The
GLVSOD\ FKDQJHV PRPHQWDULO\ WR 5(48(67 0$'( WR FRQÀUP \RXU
request was sent.
Fire Drill
)LUH'ULOOLVXVHGWRWHVWWKHÀUHEHOOVRUÀUHKRUQVLQ\RXUV\VWHP
The Fire Drill test turns your system bell circuit on, but does not
send a message to the central station.
Starting a Fire Drill test
1. Access the User Menu.
2. Press COMMAND until FIRE DRILL? displays. Press any Select
key.
3. The keypad displays SURE? YES NO.
4. Select YES to start the Fire Drill test.
Ending a Fire Drill test
1. Enter your code at the keypad and press COMMAND to end
the Fire Drill.
2. The Fire Drill test automatically ends with ALARM SILENCE
or the programmed Bell Cutoff time.