38 XR500/XR100 User’s Guide User Menu
5. If Opening and Closing times display, the keypad then
displays DELETE KEEP. Select DELETE to enter new
times.
6. The keypad then displays OPENING TIME? followed by the
display MON – : AM PM. Enter the new opening time
and select AM or PM.
Enter all schedule times using a 12 hour clock. For example,
to enter 6 AM you would enter a 0 + 6 + 0 + 0 and select AM.
For 11 PM you would enter a 1 + 1 + 0 + 0 and select PM.
The keypad then displays CLOSING TIME? followed by the
display MON – : AM PM. Enter the new closing time
and select AM or PM. Select whichever day displays, for
example, MON, allows you to scroll through the days of the
week and create a schedule window that spans multiple
days.
Note: You must enter an Opening and Closing time or the
system will not recognize the schedule.
The new schedule is now programmed into your system.
7. The keypad goes back to the SUN MON TUE WED display
allowing you to enter another schedule.
8. To clear a schedule press DELETE and then AM when the
opening time is requested.
Press the Back Arrow key to exit the User Menu.
Note: Your system may be programmed to limit the Panic
Zone Test to only be performed during the Area 32, Shift 4
schedule.
Setting Output (OUT) and Door (DOOR) Schedules
The Schedules function allows you to set up to 100 different
scheduled times for relay outputs and door access relays connected
to your system to turn ON and OFF automatically. The maximum
number of schedules that can be assigned per door access relay or
relay output is 8.
1. Access the User Menu.
2. Press COMMAND until SCHEDULES? displays.
3. After you have accessed the SCHEDULES? menu and the
schedule options, S1 S2 S3 S4, display, press the COMMAND
key once more and the display changes to OUT DOOR HOL
EXT. Select OUT or DOOR.
4. At the OUTPUT NO: – or DOOR NO: – display, enter the
output or door number you want to program. Press the
COMMAND key.
If adding a schedule and all 100 scheduled times are currently in
use, OUT SCHEDS FULL displays. You must then delete an existing
schedule.
5. The keypad displays SCHEDULE NO: -. Enter the schedule
number (1 to 8) and press the COMMAND key.
6. The keypad displays SUN MON TUE WED. Press the COMMAND
key to display THU FRI SAT HOL.
7. Select the day you want to program. If you select HOL go to
Setting Holiday ABC Schedules for more information.
To Next Page
Loading...
Need help?
General
