28 XR Fire Control Panel User Guide | Digital Monitoring Products, Inc.
Using the Panic Zone Test (XR550DNFC with Network)
1. Access the User Menu. Press COMMAND until SYSTEM TEST? displays.
2. Press any Select Key. The keypad displays SYSTEMPANICS.
3. Press the Select Key below PANICS.
4. The Panic Zone Test begins automatically and the keypad displays
TRIPS:END.
5. During the test, trip each panic zone (or button) on the system by pressing
and holding the panic for 1 to 2 seconds.
Note: You do not have to hold the panic for 2 seconds in normal
mode. You are only required to hold the panic during the Panic Zone
Test because the zone takes additional time to report when the system
is in test mode.
Each time you trip a panic zone, the display number increments and the
keypad buzzer sounds for two seconds.
The number of panic zones tripped constantly displays until the test ends
or no panic zone activity has occurred for 20 minutes.
6. Press the Select Key below END to stop the Panic Zone Test.
To Next Page
Loading...
