56 XR Fire Control Panel User Guide | Digital Monitoring Products, Inc.
Fire Drill is used to test the fire bells or fire horns in your system. The Fire Drill
test turns your system bell circuit on, but does not send a message to the central
station.
Starting a Fire Drill test
1. Access the User Menu. Press COMMAND until FIRE DRILL? displays. Press
any Select Key.
2. The keypad displays SURE? YES NO.
3. Press the Select Key under YES to start the Fire Drill test.
Ending a Fire Drill test
1. Enter your code at the keypad and press COMMAND to end the Fire Drill.
2. The Fire Drill test automatically ends with ALARM SILENCE or the
programmed Bell Cuto time.
Fire Drill
To Next Page
Loading...
Need help?
General
