DMP Electronics XR200 User Manual

XR200/XR2400F Programming Guide Digital Monitoring Products
45
17.10 462N Network Interface Card Examples
Several options are available when configuring the panel for Host communication, Host backup communication, and
Host Log Reports. All options use a 462N card and an iCOM Internet Alarm Router (an iCOM is not required for the
Host Log Reports when a direct connection is used).
The chart below outlines the different ways you can configure the panel for these three options. As shown in the
chart below, it is possible to use only one 462N card an one iCOM to meet all three of these needs. The chart also
explains when a Modem Setup is required.
When using a direct connection to a Advanced Reporting Module computer for the Host Log Reports, the 462N card
can only be used for logging: A separate card will be needed for Host Communication and Host Backup. Also, a
Modem Setup is not required when using a direct connection for the logger.
Refer to the Communication section and Host Log Reports section for more information. Also refer to Modem Setup
Information and Host Backup Examples in the Appendix.
17 - APPENDIX
snoitpOgnimmargorPlenaPdraC1sdraC2
tsoHpukcaBtsoHstropeRgoLtsoH1draC1draC2draC
seYoNoNtsoH
seYseYoN)pukcaBrofputeSmedoM(pukcaB,tsoHtsoH)pukcaBrofputeSmedoM(pukcaB
seYseYseY
puteSmedoM(gniggoLdna,pukcaB,tsoH
)gniggoLdnapukcaBrof
puteSmedoM(pukcaB,tsoH
)pukcaBrof
gniggoLrofputeSmedoM(gniggoL
seYseYseY
puteSmedoM(gniggoLdna,pukcaB,tsoH
)gniggoLdnapukcaBrof
puteSmedoM(gniggoL,tsoH
)gniggoLrof
)pukcaBrofputeSmedoM(pukcaB
seYoNseY)gniggoLrofputeSmedoM(gniggoL,tsoHtsoHgniggoL
oNoNseYgniggoL

DMP Electronics XR200 Specifications

General

Brand	DMP Electronics
Model	XR200
Category	Control Panel
Language	English