XR200/XR2400F Programming Guide Digital Monitoring Products
viii
TABLE OF CONTENTS
PageSection
REVISIONS
Revisions to This Document
This section explains the changes that were made to this document during this revision. This section lists the date
and the change that was made, the section number and section heading, and a quick summary of the change.
Date Section Number and Heading Quick Explanation of Changes
5/02 2.2 Clear All Memory Programming Prompt added to initialize all programming.
5/02 3.6 DTMF Programming Default changed to YES
5/02 3.9 Test Frequency Programming Default changed to 1
5/02 7.4 Cross Zone Time Programming Default changed to 4.
5/02 17.10 462N Examples Table revised for clarity.
3/02 3.2.4 UL AA Check-in Time and Fail Time defaults changed to 1 (one).
1/02 3 Communication DNET programming type removed.
1/02 12 Host Log Reports Section added for Host Log Reports feature.
Note: All subsequent section numbers adjusted.
1/02 17.9 462N Examples Section added to explain how to use the 462N card with Host Log
Reports, Host Communication, and Host Backup.
12/01 3.2.1 Retry Time Section added for new programming operation.
12/01 3.2.2 Host Backup Section added for new programming operation.
12/01 3.2.3 Modem Setup Section expanded for new programming operation.
12/01 3.2.4 UL AA Section added for new programming operation.
12/01 16 Appendix Entire section rearranged for clarity.
21/01 16.3 Using the Walk Test Clarification added regarding bells.
12/01 16.5 Pager Direct Specifications Information added about Pager Direct.
12/01 16.6 Cross Zoning Clarification added about method of reporting tripped cross zones.
12/01 16.8 Modem Setup Information Information added regarding modem setup strings.
12/02 16.9 Host Backup Examples Scenarios for Host Backup added for clarity.
12/01 16.12 Common Keypad Examples Section added to help troubleshoot some common keypad messages
that may appear on the keypad display.
12/01 Entire Document New Layout.
To Next Page
Loading...
Need help?
General
