XR200/XR2400F Programming Guide Digital Monitoring Products
33
14.6.4 Style
This option specifies the style for the arming/disarming operation. The default
for STYLE: is TGL (toggle). Pressing any top row select key will display the STYLE
options. To view more style options press the command key. The following is a
description of the action for each option.
TGL (Toggle)
When the zone changes from normal to shorted, the programmed areas toggle
between the armed or disarmed condition. When restored to normal, no action
occurs. When the zone is opened from a normal (disarmed) state, a trouble is
reported. When opened from a shorted (armed) state, an alarm is reported and
the zone is disabled until you disarm the area(s) from either a keypad or Remote
Link.
ARM
When the zone is shorted, the programmed areas are armed. When restored to
normal, no action occurs. When the zone is opened from a normal (disarmed)
state, a trouble is reported. When opened from a shorted (armed) state, an alarm
is reported.
DIS (Disarm)
When programmed as an AREA system, a short will disarm the programmed areas.
When programmed as a ALL/PERIM or HOME/AWAY system, a short will disarm ALL
areas. When restored to normal, no action occurs. When the zone is opened from
a normal (disarmed) state, a trouble is reported.
STEP
When programmed as an AREA system, a short will arm the areas and beep the
keypads once. When programmed as ALL/PERIM or HOME/AWAY, on the first short
HOME (PERIMETER) will arm and beep the keypads once. On the second short,
SLEEP will arm for HOME/AWAY systems and beep the keypads twice. When
programmed as ALL/PERIM, the INTERIOR will arm and beep the keypads twice.
On the third short, AWAY will arm and beep the keypads three times. A normal
condition will cause no action. An open condition will disarm the programmed
areas and beep the keypads for one second.
Note: This arming style is designed for wireless arming pendants. When using a
arming/disarming keyswitch locate the keyswitch within the protected area.
MNT (Maintain)
When the zone is shorted, the programmed areas are armed. When restored to
normal, the programmed areas are disarmed and any alarm bells are silenced.
When the zone is opened from a normal (disarmed) state, a trouble is reported. If
opened from a shorted (armed) state, an alarm is reported and the zone is
disabled until you disarm the area(s) from either a keypad or Remote Link.
14.7 Next Zone
When YES is selected, the programming for the zone terminates and the display
returns to Zone Number, allowing you to enter a new zone number. To make any
alterations to the Alarm Action for a zone, answer the Next Zone prompt with NO.
The Alarm Action is then defined in the following sections.
NOTE: The following five prompts are for use with an FA400 Remote Wireless
Receiver.
Zones 100 through 299 have wireless capability when using the FA400 Remote
Wireless Receiver: If you are programming zones 100 to 299, selecting NO to
NEXT ZONE - NO YES displays the prompt WIRELESS NO. This display is not
visible unless you are programming zones in this range. If the zone you are
programming is intended for wireless devices, select YES and refer to the
programming instructions below. Select NO to continue programming non-wireless
zones in the 100 to 299 range.
NEXT ZN? NO YES
STYLE:
TGL ARM DIS STEP
14 - ZONE INFORMATION